Nissan Rogue Service Manual

- Foreword
- General information
- Engine
- Engine Mechanical
- Engine Lubrication System
- Engine Cooling System
- Engine Control System
- Fuel System
- Exhaust System
- Starting System
- Accelerator Control System
- Transmission & driveline
- Suspension
- Brakes
- Steering
- Restraints
- Ventilation, heater & air conditioner
- Body interior
- Body exterior, doors, roof & vehicle security
- Door & Lock
- Security Control System
- Glass & Window System
- Power Window Control System
- Roof
- Exterior
- Body Repair Manual
- Driver controls
- Electrical & power control
- Power Outlet
- Body Control System
- LAN System
- Power Control System
- Charging System
- Power Supply, Ground & Circuit Elements
- Driver information & multimedia
- Cruise control
- Maintenance
Owner’s Manual/Service Manual order information
Genuine NISSAN Service Manuals for this model
year and prior can be purchased. A genuine
NISSAN Service Manual is the best source of
service and repair information for your vehicle.
This manual ...
Foreword
This manual contains maintenance and repair procedure for the 2014
NISSAN ROGUE.
In order to assure your safety and the efficient functioning of the vehicle,
this manual should be read thoroughly ...
Other materials:
Compression pressure
CHECKING COMPRESSION PRESSURE
Warm up the engine to full operating temperature.
Release the fuel pressure. Refer to EC-144, "Work Procedure".
Remove the ignition coil and spark plug from each cylinder. Refer
to EM-36, "Removal and Installation"
and ...
P0779 pressure control solenoid B
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0779
Pressure control solenoid B Inte
When all of the following conditions are satisfied and this state is
maintained
for 0.2 seconds:
T ...
Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time the harness connector
of the electric throttle control actuator or ECM is ...
