Nissan Rogue Service Manual: Power Control System

CAN system (type 8)

MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF.  Disconnect the battery cable from the negative terminal.  Check ...

IPDM E/R

...

Other materials:

Periodic maintenance
REAR DIFFERENTIAL GEAR OIL Inspection OIL LEAKS Make sure that oil is not leaking from final drive assembly or around it. OIL LEVEL  Remove filler plug (1) and check oil level from filler plug mounting hole as shown. CAUTION: Do not start engine while checking oil level. &nbs ...

Water pump
Exploded View Cylinder block Water pump  Water pump gasket  Water pump housing  O-ring  Water pipe Water pump housing gasket  Refer to INSTALLATION Removal and Installation REMOVAL  Drain engine coolant. Refer to CO-8, "Draini ...

P0643 sensor power supply
Description ECM supplies a voltage of 5 V to some of the sensors systematically divided into 2 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the short-circuited ...