Nissan Rogue manuals

Nissan Rogue Service Manual: Removal and installation

Oil filter
Removal and Installation REMOVAL  Remove fender protector side cover (RH). Refer to EXT-28, "FENDER PROTECTOR : Exploded View".  Drain engine oil. Refer to LU-8, "Dr ...

Oil cooler
Exploded View  Intake manifold Cylinder block  Clamp  Water hose Water hose clip  Water hose  Oil cooler  Gasket  Oil cooler relief val ...

Other materials:

Recommended fluids and lubricants
Fluids and Lubricants *1: For additional information, see “Engine Oil Recommendation”. *2: As an alternative to this recommended oil, SAE 5W-30 conventional petroleum based oil may be used and meet all specifications and requirements necessary to maintain the New Vehicle Limited Warra ...

Periodic maintenance
HEADLAMP AIMING ADJUSTMENT Inspection PREPARATION BEFORE ADJUSTING Before performing aiming adjustment, check the following:  Make sure all tires are inflated to correct pressure.  Place vehicle and screen on level surface.  Make sure there is no load in vehicle other than ...

Performance test
Inspection INSPECTION PROCEDURE  Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge.  Start the engine, and set to the following condition. Test condition Maintain test condition until A/C system becomes stable. (Approximately 10 minute ...

© 2014-2019 Copyright www.nirogue.com