Nissan Rogue Service Manual: SRS air bag warning lamp does not turn off
AIR BAG Warning Lamp Does Not Turn Off
1.CHECK CONDITION OF AIR BAG MODULE
Inspect for any deployed air bag modules or seat belt pre-tensioners.
Are any air bag modules or seat belt pre-tensioners deployed? YES >> Refer to Frontal collision: SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision", SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision" or Side and rollover collision: SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision", SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision".
NO >> GO TO 2.
2.CHECK THE AIR BAG FUSE
Check 10A fuse [No. 32, located in the fuse block (J/B)].
Is the fuse blown? YES >> GO TO 3.
NO >> GO TO 4.
3.CHECK AIR BAG FUSE AGAIN
Replace 10A fuse [No. 32, located in the fuse block (J/B)] and turn ignition switch ON.
Does the fuse blow again? YES >> Replace fuse and harness.
NO >> Inspection End.
4.CHECK AIR BAG DIAGNOSIS SENSOR UNIT
Connect CONSULT.
Is “AIR BAG” displayed on CONSULT? YES >> GO TO 5.
NO >> Visually inspect the air bag diagnosis sensor unit harness connections. If the connections are OK, replace the air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".
5.CHECK HARNESS CONNECTION
Check for loose connections between the combination meter and the air bag diagnosis sensor unit.
Are there any loose connections? YES >> Properly connect the combination meter and air bag diagnosis sensor unit harness connectors. If AIR BAG warning lamp still does not turn off, replace the wiring harness.
NO >> Replace air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".
SRS air bag warning lamp does not turn on
AIR BAG Warning Lamp Does Not Turn On
1.CHECK METER FUSE
Check the 10A fuse [No. 13, located in the fuse block (J/B)].
Is the fuse blown?
YES >> GO TO 2.
NO >> GO TO 3.
2.REPLACE ...
Seat belt warning system
Seat Belt Warning System Does Not Function
1.SEAT BELT WARNING LIGHT
Turn ignition switch ON.
Does the seat belt warning lamp come ON?
YES >> GO TO 2.
NO >>
Check 10A f ...
Other materials:
The light reminder warning does not sound
Description
Light reminder warning does not sound even though headlamp is illuminated.
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT SIGNAL
Select the "Data Monitor" for the "METER/M&A" and check the "BUZZER" monitor
value.
Is the inspection result ...
Oil pan and oil strainer
Exploded View
Oil pan, upper
Oil filter
Front cover
O-ring
Oil strainer
Oil pan, lower
Washer
Drain plug
O-ring
Oil level gauge guide
Oil level gauge
Rear cover plate
To Oil pan, lower
Removal and In ...
Basic inspection
SERVICE INFORMATION FOR ELECTRICAL INCIDENT
Work flow
STEP
DESCRIPTION
STEP 1
Get detailed information about the conditions and the
environment when the incident occurred.
The following are key pieces of information required to make a good
analysis:
WH ...
