Nissan Rogue Service Manual: DTC/circuit diagnosis
- B0001, B0002 driver airbag module
- B0010, B0011 passenger airbag module
- B0020 side airbag module IH
- B0028 side airbag module RH
- B0021 side curtain air bag module IH
- B0029 side curtain air bag module RH
- B1430 seat belt pre-tensioner
- B1431 seat belt pre-tensioner
- B1428 seat belt buckle switch IH
- B1429 seat belt buckle switch RH
- B0094 crash zone sensor
- B0093 front door satellite sensor LH
- B0098 front door satellite sensor RH
- B0091 front side air bag satellite sensor LH
- B0096 front side air bag satellite sensor RH
- B0092 rear side air bag satellite sensor LH
- B0097 rear side air bag satellite sensor RH
- B00A0 OCS system
- B14XX air bag diagnosis sensor unit
- B00D5 front passenger air bag off indicator
- B142A ignition voltage
- U1000 CAN COMM circuit
- U1010 control unit (CAN)
- B142X collision detection
Intermittent incident
Inspection Procedure
INTERMITTENT TROUBLE
An intermittent incident may have occurred in the past but is not being
detected currently. This DTC will not be
detected on SELF-DIAG [CURRENT], but may ...
B0001, B0002 driver airbag module
DTC Logic
DTC DETECTION LOGIC
CONSULT name
DTC
DTC detecting condition
Repair order
DRIVER AIRBAG MODULE CIRCUIT
[OPEN]
B0001
Driver air bag module ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Additional service when replacing TCM and transaxle assembly
Description
When replacing TCM and transaxle assembly simultaneously, perform the
following work.
TCM PROGRAMMING
Since vehicle specifications are not yet written in a new TCM, it
is necessary to write them with CONSULT.
CAUTION:
When replacing TCM, save TCM data on CONSULT be ...
Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
When replacing the occupant classification system control unit, perform
zero point reset procedure. Refer to
SRC-42, "ZERO POINT RESET : Special Repair Requirement".
When ...
