Nissan Rogue Service Manual: U1010 control unit (CAN)
Description
Air bag diagnosis sensor performs self-tests on key ON. If CAN communication failure within control unit is detected, DTC is set.
DTC Logic
DTC DETECTION LOGIC
|
CONSULT name |
DTC |
DTC detecting condition |
Repair order |
| CAN CONTROL UNIT FAILURE | U1010 | CAN communication error is detected in control unit. | Refer to SRC-96, "Diagnosis Procedure". |
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF-DIAGNOSIS
- Turn ignition switch ON.
- Using CONSULT, perform SELF DIAGNOSIS RESULTS of AIR BAG.
- Check if DTC is displayed in the self-diagnosis results.
Is DTC detected? YES >> Refer to SRC-96, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
Replace air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".
>> Inspection End.
U1000 CAN COMM circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and exce ...
B142X collision detection
Description
DTC B1209 - B1211 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a deployment
of one or more air bags or ...
Other materials:
Luggage hooks
When securing items using luggage hooks located
on the back of the seat or side finisher do
not apply a load over more than 6.5 lbs (29 N) to
a single hook.
The luggage hooks that are located on the floor
should have loads less than 110 lbs (490 N) to a
single hook.
The luggage hooks ...
Rapid air pressure loss
Rapid air pressure loss or a “blow-out” can occur
if the tire is punctured or is damaged due to
hitting a curb or pothole. Rapid air pressure loss
can also be caused by driving on under-inflated
tires.
Rapid air pressure loss can affect the handling
and stability of the vehicle, especial ...
Air bag diagnosis sensor unit
Exploded View
Diagnosis sensor unit
Front
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Before disconnecting the air bag diagnosis sensor unit harness
...
