Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Installing top tether strap

WARNING

  • Child restraint anchorages are designed only for loads from correctly installed child restraints. Never attach adult belts or other equipment to them. Damage could compromise safety and lead to serious injury or death.
  • Do not attach the tether hook to the seatback carpet. Always use the designated tether anchor point.

The top tether strap must be used when installing a forward-facing child restraint with LATCH lower anchors in your Nissan Rogue.

First, secure the child restraint with the lower anchors.

1. Remove the head restraint/headrest and store it in a secure area. Reinstall it after the restraint is removed.

2. Position the top tether strap as shown.

3. Attach the top tether strap to the tether anchor point.

4. Refer back to the child restraint installation steps before tightening the strap fully.

If you have questions about installing a top tether strap, it is recommended to visit a NISSAN dealer for assistance.

    Forward-facing child restraint installation using LATCH
    Basic information For proper installation of a forward-facing child restraint in your Nissan Rogue, carefully review all Warnings and Cautions in the “Child safety” and “C...
    Forward-facing child restraint installation using the seat belts
    Basic information WARNING The three-point seat belt with ALR mode must be used when installing a child restraint. Not using ALR will result in an unsecured restraint, increasing...

    Other materials:

    Variable Compression Ratio Motor Rotation Angle Sensor
    Component Inspection CHECK VCR MOTOR ROTATION ANGLE SENSOR Turn ignition switch OFF. Disconnect VCR motor rotation angle sensor harness connector. Check the continuity between VCR motor rotation angle sensor harness connectors. VCR motor rotation angle sensor Continuity Termina ...

    U2141-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2141–87 CAN comm err (TCM) [Controller area network communication error (TCM)] Diagnosis condition When ignition switch is ON Signal (terminal) CAN commu ...

    Paddle Shifter
    Removal and Installation REMOVALFor servicing the Japan production paddle shifter, service the Japan production steering wheel. Refer to Removal and Installation.NOTE: The Japan production paddle shifter is serviced as an assembly with the Japan production ASCD steering switch (if so equip ...