Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Anti-Pinch Inspection

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Power Window Control System / Basic Inspection :: Anti-Pinch Inspection

Description

If any of the following operations are performed, the initialization is necessary for normal operation of anti-pinch function. Refer to Work Procedure.

  • When front power window motor (driver side) replaced.

  • Power supply to the front power window motor (driver side) is not cut off properly.

  • Removal and installation of regulator assembly.

  • Removal and installation of front power window motor (driver side) from regulator assembly.

  • Operation of regulator assembly as an independent unit.

  • Removal and installation of door glass.

  • Removal and installation of door glass run.

Work Procedure

CHECK ANTI-PINCH FUNCTION

  1. Fully open the front door glass (driver side).

  2. Place a piece of wood near fully closed position.

  3. Close front door glass (driver side) completely with AUTO-UP.

  4. Check the following conditions.

    • Check that front door glass (driver side) lowers for 5.71 in (145 mm) without pinching piece of wood and stops.

    • Check that front door glass (driver side) does not rise when operating the power window main switch while lowering.

      CAUTION:

      • Perform initial setting when AUTO-UP operation or anti-pinch function does not operate normally.

      • Check that AUTO-UP operates before inspection when system initialization is performed.

      • Never check with hands and other body parts because they may be pinched. Never get pinched.

>>

Inspection End.

    Basic Inspection. System Initialization
    Description If any of the following operations are performed, the initialization is necessary for normal operation of power window system. Refer to Work Procedure. When front po...
    Dtc/circuit Diagnosis. B2c40-04 Power Window Main Switch
    DTC Description NOTE: When the ignition switch is placed ON, the DTC may be detected. If it has been detected due to previous error/operation, erase the history once and check i...

    Other materials:

    C1f03-72 Stop Lamp Relay
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F03 72 OPERATION SW CIRC (Operation switch circuit) Diagnosis condition When engine is running When AEB system is ...

    Repair Information. Preparation
    Repairing Material Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Ariya vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially availabl ...

    Active Grille Shutter
    Component Inspection CHECK ACTIVE GRILLE SHUTTER With CONSULT Start the engine. Select “ACTIVE GRILLE SHUTTER” in “ACTIVE TEST” mode of “ENGINE” using CONSULT. Touch “CALIBRTN”. After the calibration completes, check the operation of active grille shutter as fol ...