Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: System Initialization

Description

If any of the following operations are performed, the initialization is necessary for normal operation of power window system. Refer to Work Procedure.

• When front power window motor (driver side) replaced.

• Power supply to the front power window motor (driver side) is not cut off properly.

• Removal and installation of regulator assembly.

• Removal and installation of front power window motor (driver side) from regulator assembly.

• Operation of regulator assembly as an independent unit.

• Removal and installation of door glass.

• Removal and installation of door glass run.

CAUTION:

The following specified operations cannot be performed under the non-initialized condition:

Work Procedure

STEP 1

1. Close the door.

2. Ignition switch ON.

3. Continue pulling the power window switch UP until glass stops at fully closed position then release the switch. ^*1

4. Keep pulling the switch for 5 seconds or more. ^*2

5. Continue pressing the power window switch DOWN until glass stops then release the switch.

6. Keep pressing the switch for 5 seconds or more. ^*2

   After glass moves again, keep pressing the switch until glass reaches the fully open position.

7. Continue pulling the power window switch UP (MANUAL-UP operation) until glass stops at fully closed position.

8. Check that AUTO-UP function operates normally.

NOTE:

^*1: If the power window stops before reaching the fully closed position: After the power window stops, release the switch then continue pulling the switch UP again and move the power window to the fully closed position.

GO TO 2.

STEP 2

Check anti-pinch function. Refer to Description.

Inspection End.