Nissan Rogue (T33) 2021-Present Service Manual: Ssg Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Ssg Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the sub starter & generator for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of sub starter & generator.

  2. Check the resistance between the sub starter & generator harness connector terminals.

    Sub starter & generator harness connector Resistance (Ω)
    Connector No. Terminal No.
    F126 1 2 Approx. 54 – 66

Is the measurement value within the specification?

YES>>

GO TO 3.

NO>>

Repair the sub starter & generator branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the sub starter & generator. Refer to the following .

  • With ProPILOT Assist 2.1: Wiring Diagram (With ProPILOT Assist 2.1)

  • Without ProPILOT Assist 2.1: Wiring Diagram (Without ProPILOT Assist 2.1)

Is the inspection result normal?

YES (Present error)>>

Replace the sub starter & generator. Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the sub starter & generator branch line.

NO>>

Repair the power supply and the ground circuit.

    Abs Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...
    Tcm Branch Line Circuit (drivetrain Can Communication 1 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the TCM for dama...

    Other materials:

    Removal and Installation. Back Door
    Exploded View Roof seal Back door weather-strip Back door hinge LH Back door stay LH* Stud ball Back door bumper rubber upper Back door bumper rubber lower Back door striker TORX bolt Back door panel Back door stay RH* Back door hinge RH ...

    U0074-00 Av Communication
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0074-00 Control module comm Bus B Off (Control module communication bus B off) Diagnosis condition When ignition switch is ON Signal (terminal) AV communic ...

    P0365 Exhaust Camshaft Position Sensor
    DTC Description DTC DETECTION LOGIC Exhaust camshaft position sensor signal is not sent to ECM during engine running. The pulse signal sent from the exhaust camshaft position sensor to ECM is not in the normal pattern during engine running. DTC CONSULT screen terms (Trouble diagnos ...