Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Additional Service When Replacing Power Window Motor

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Power Window Control System / Basic Inspection :: Additional Service When Replacing Power Window Motor

Description

When front power window motor (driver side) replaced, the initialization is necessary for normal operation of power window system. Refer to Work Procedure.

CAUTION:

The following specified operations cannot be performed under the non-initialized condition:

  • Auto-up operation

  • Anti-pinch function

Work Procedure

SYSTEM INITIALIZATION

Perform system initialization. Refer to Description.

>>

GO TO 2.

CHECK ANTI-PINCH FUNCTION

Check anti-pinch function. Refer to Description.

>>

Inspection End.

    Basic Inspection. Diagnosis and Repair Work Flow
    Work Flow OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incid...
    Basic Inspection. System Initialization
    Description If any of the following operations are performed, the initialization is necessary for normal operation of power window system. Refer to Work Procedure. When front po...

    Other materials:

    Symptom Diagnosis. Unbalance Steering Wheel Turning Force and Return Between Right and Left
    Description Unbalance steering wheel turning force and return between right and left. Diagnosis Procedure PERFORM SELF-DIAGNOSIS CONSULT Pull the parking brake switch. NOTE: Check to make sure that the parking brake switch indicator is turned ON. Ignition switch OFF. Get out ...

    Fuel information
    Basic information Use unleaded regular gasoline with an octane rating of at least 87 AKI (Anti-Knock Index) number (Research octane number 91), as recommended for your Nissan Rogue. CAUTION Using a fuel other than specified may negatively affect the emission control system of your Nissan Rogue an ...

    C1b80-54 Control Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1B80 54 Calibration not completed Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold When calibration is not complete. Diagnosis delay time 1 ...