Nissan Rogue (T33) 2021-Present Service Manual: Power Supply and Ground Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Audio, Visual & Navigation System / Intelligent Around View Monitor :: Dtc/circuit Diagnosis / Power Supply and Ground Circuit

Around View Monitor Control Unit

Diagnosis Procedure

CHECK FUSE

Check that the following fuse is not blown (open).

Power source Fuse No. Capacity
ACC power supply 40 10 A
1131 10 A1

1: With ProPILOT Assist 2.1

Is the fuse blown (open)?

YES>>

Be sure to eliminate cause of malfunction before installing new fuse.

NO>>

GO TO 2..

CHECK AROUND VIEW MONITOR CONTROL UNIT POWER SUPPLY CIRCUIT

  1. Turn ignition switch ON.

  2. Check voltage between around view monitor control unit harness connector and ground.

    (+) (–) Standard

    Reference voltage

    (Approx.)
    Around view monitor control unit
    Connector Terminal
    B75 11 Ground 9.5 - 16 V Battery voltage
    17

    1: With ProPILOT Assist 2.1

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair the around view monitor control unit power supply circuit.

CHECK AROUND VIEW MONITOR CONTROL UNIT GROUND CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect around view monitor control unit connector.

  3. Check for continuity between around view monitor control unit harness connector and ground.

    Around view monitor control unit Ground Continuity
    Connector Terminal
    B75 16 Yes
    311

    1: With ProPILOT Assist 2.1

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair the around view monitor control unit ground circuit.

    Avm (around View Monitor Control Unit)
    B2a00-52 Side Camera Lh DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition B2A00-52 Left camera Diagnosis condition When ignition switch is ON ...
    Intelligent Around View Monitor. Symptom Diagnosis
    Intelligent Around View Monitor Symptom Table INTELLIGENT AROUND VIEW MONITOR SYSTEM Symptoms Check items Probable malfunction location Screen is not switched to camera image, w...

    Other materials:

    Heated Oxygen Sensor 2
    Component Function Check PERFORM COMPONENT FUNCTION CHECK-1 Without CONSULT Start engine and warm it up to normal operating temperature. Turn ignition switch OFF and wait at least 10 seconds. Start engine and keep the engine speed between 3,500 and 4,000 rpm for at least 1 minute u ...

    Component Parts
    Engine Control System Component Parts Location ENGINE ROOM COMPARTMENT Right front of Nissan Ariya vehicle Left front of vehicle     Nissan Ariya Vehicle front         IPDM E/R ECM Admission valve Turbocharger boost senso ...

    Basic Inspection. Additional Service When Replacing Intelligent Key Unit
    Description CAUTION: When replacing the Intelligent Key unit, always replace it with a new one. The functions controlled by the Intelligent Key unit does not operate properly in case of reuse of the Intelligent Key unit from another Nissan Ariya vehicle. Perform the following operations whe ...