Nissan Rogue (T33) 2021-Present Service Manual: Accelerator Pedal Position Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Accelerator Pedal Position Sensor

Component Inspection

CHECK ACCELERATOR PEDAL POSITION SENSOR

  1. Turn ignition switch OFF.

  2. Reconnect all harness connectors disconnected.

  3. Turn ignition switch ON.

  4. Check the voltage between ECM harness connector terminals as per the following condition.

    ECM Condition

    Voltage

    (Approx.)
    Connector + –
    Terminal
    Sensor 1 E25 158 159 Accelerator pedal Fully released 0.76 V
    Fully depressed 4.57 V
    Sensor 2 151 152 Fully released 0.39 V
    Fully depressed 2.3 V

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace accelerator pedal assembly. Refer to Removal and Installation.

    A/f Sensor 1 Heater
    Component Inspection CHECK AIR FUEL RATIO (A/F) SENSOR 1 Turn ignition switch OFF. Disconnect A/F sensor 1 harness connector. Check resistance between A/F sensor 1 terminals as ...
    Active Grille Shutter
    Component Inspection CHECK ACTIVE GRILLE SHUTTER With CONSULT Start the engine. Select “ACTIVE GRILLE SHUTTER” in “ACTIVE TEST” mode of “ENGINE” using CONSULT. Touch...

    Other materials:

    Automatic Brake Hold. Symptom Diagnosis. Does Not Operate
    Does Not Operate Diagnosis Procedure Automatic brake hold function does not operate when the operating conditions are satisfied.PERFORM SELF-DIAGNOSIS (CHASSIS CONTROL MODULE) With CONSULT Perform self-diagnosis for “CHASSIS CONTROL”. Is DTC detected? YES>> Check the DTC. With ...

    Towing your vehicle
    Basic information When towing your vehicle, always follow local towing laws and regulations. Using incorrect equipment or improper towing procedures can damage your vehicle. Professional service operators typically know the proper towing methods. To prevent accidental damage, NISSAN recommends ha ...

    Dtc/circuit Diagnosis. Eps Warning Lamp
    Component Function Check CHECK THE ILLUMINATION OF THE ELECTRIC POWER STEERING WARNING LAMP Check that the electric power steering warning lamp turns ON when ignition switch ON. Then, electric power steering warning lamp turns OFF after the engine is started. Is the inspection result normal? ...