Nissan Rogue (T33) 2021-Present Service Manual: A/f Sensor 1 Heater
Component Inspection
CHECK AIR FUEL RATIO (A/F) SENSOR 1
-
Turn ignition switch OFF.
-
Disconnect A/F sensor 1 harness connector.
-
Check resistance between A/F sensor 1 terminals as per the following.
A/F sensor 1 Resistance + − Terminal 3 4 1.8 - 2.44 Ω [at 20°C (68°F)] 1 ∞Ω
(Continuity should not exist)2 4
1 2
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 2.
REPLACE AIR FUEL RATIO (A/F) SENSOR 1
Replace air fuel ratio (A/F) sensor 1. Refer to Exploded View.
>>
INSPECTION END
Other materials:
Fuel Pump
Component Inspection
CHECK FUEL PUMP
Turn ignition switch OFF.
Disconnect “fuel level sensor unit and fuel pump� harness connector.
Check the resistance between “fuel level sensor unit and fuel pump� terminals as follows.
Fuel level sensor unit and fuel pump Condition Res ...
Removal and Installation. Automatic Back Door Lock and Close Switch Assembly
Removal and Installation
REMOVALRemove automatic back door lock and close switch
assembly and automatic back door close switch finisher. Refer to
Removal and Installation.
Remove automatic back door lock and close switch assembly fixing screws and then remove automatic back door lock and clos ...
Towing your vehicle
Basic information
When towing your vehicle, always follow local towing laws and regulations. Using incorrect equipment or improper towing procedures can damage your vehicle. Professional service operators typically know the proper towing methods.
To prevent accidental damage, NISSAN recommends ha ...
