Nissan Rogue (T33) 2021-Present Service Manual: Exhaust Gas Temperature Sensor
Component Inspection
CHECK EXHAUST GAS TEMPERATURE SENSOR
-
Turn ignition switch OFF.
-
Disconnect exhaust gas temperature sensor harness connector.
-
Check resistance between exhaust gas temperature sensor connector terminals.
Exhaust gas temperature sensor Resistance (kΩ) Connector Terminal E26 1 2 0.005 - 156
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace exhaust gas temperature sensor. Refer to Component Parts Location.
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Let engine idle for 1 minutes.
-
Check the DTC.
Is DTC detected?
YES>>Replace exhaust gas temperature sensor. Refer to Component Parts Location.
NO>>INSPECTION END
Other materials:
Basic Inspection. System Initialization
Description
Initialization of system should be conducted after the following conditions: Refer to Work Procedure.
When the moonroof motor assembly or sunshade motor assembly is replaced.
When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions)
Wor ...
Removal and Installation. Room Lamp
Exploded View
Headlining assembly
Room lamp housing
Bulb
Lens
: Pawl
: Nissan Ariya Vehicle front
Removal and Installation
REMOVALCAUTION:
Disconnect the battery negative terminal or remove power
circuit fuse when performin ...
P2127 App Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2127
00
APP SEN 2/CIRC
(Throttle/Pedal position sensor/switch E circuit low)
Diagnosis condition
Engine running at idle
Signal (terminal)
Accelerator ...
