Nissan Rogue (T33) 2021-Present Service Manual: Active Grille Shutter

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Active Grille Shutter

Component Inspection

CHECK ACTIVE GRILLE SHUTTER

With CONSULT

  1. Start the engine.

  2. Select “ACTIVE GRILLE SHUTTER” in “ACTIVE TEST” mode of “ENGINE” using CONSULT.

  3. Touch “CALIBRTN”.

  4. After the calibration completes, check the operation of active grille shutter as follows.

    Condition Active grille shutter
    Select “CLOSE” Open → Close
    Select “OPEN” Close → Open

Without CONSULT

  1. Turn ignition switch OFF.

  2. Operate shutter by hands to close position.

  3. Check the operation of active grille shutter as follows.

    Condition Active grille shutter
    Ignition switch: ON Close → Open

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace active grille shutter. Refer to Removal and Installation.

    Accelerator Pedal Position Sensor
    Component Inspection CHECK ACCELERATOR PEDAL POSITION SENSOR Turn ignition switch OFF. Reconnect all harness connectors disconnected. Turn ignition switch ON. Check the voltage ...
    Admission Valve
    Component Inspection CHECK ADMISSION VALVE-1 With CONSULT Turn ignition switch ON (engine stopped). Perform “ADM/V motor target angle” in “Active Test” mode of “ENGINE...

    Other materials:

    Adas Control Unit. Ecu Diagnosis Information. Adas Control Unit 2
    Adas Control Unit 2 Without Propilot Assist 2.1 Reference Value VALUES ON THE DIAGNOSIS TOOLNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item ...

    Side Radar (front Right) (side Radar Front Rh)
    C1ec0-44 Control Unit DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1EC0 44 Control unit Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold If side radar front RH ...

    Power Supply and Ground Circuit
    Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 40 (10 A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2. CHECK ADAS CONTROL UNIT 2 POWER SUPP ...