Nissan Rogue (T33) 2021-Present Service Manual: Admission Valve

Component Inspection

CHECK ADMISSION VALVE-1

With CONSULT

1. Turn ignition switch ON (engine stopped).

2. Perform “ADM/V motor target angle” in “Active Test” mode of “ENGINE” using CONSULT.

3. Operate “Up” or “Down”, set “ADM/V Target Angle” to 0 deg, and check value “V1” of “ADMV opening angle”.

Does “V1” become 0.5 ± 0.1 V?

GO TO 2.

Replace admission valve. Refer to Removal and Installation.

CHECK ADMISSION VALVE-2

With CONSULT

Operate “Up” or “Down”, set “ADM/V Target Angle” to 70 deg, and check value “V2” of “ADMV opening angle”.

Does “V1” become 3.6 ± 0.25 V?

GO TO 3.

Replace admission valve. Refer to Removal and Installation.

CHECK ADMISSION VALVE-3

1. Turn ignition switch OFF

2. Remove admission valve. Refer to Removal and Installation.

3. Check the resistance between admission valve terminals.

   Admission valve		Resistance (Approx.)
   Terminal
   121	122	1 - 100 Ω

Is the inspection result normal?

GO TO 4.

Replace admission valve. Refer to Removal and Installation.

CHECK ADMISSION VALVE VISUALLY

Check if any foreign objects interferes with admission valve.

Is the inspection result normal?

INSPECTION END

Repair or replace error-detected parts.