Nissan Rogue (T33) 2021-Present Service Manual: Ascd Steering Switch

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Ascd Steering Switch

Component Inspection

CHECK ASCD STEERING SWITCH

  1. Turn ignition switch OFF.

  2. Disconnect combination switch (spiral cable) harness connector.

  3. Check the resistance between combination switch harness connector terminals as per the following conditions.

    Combination switch

    (Spiral cable)     		Condition

    Resistance

    (Approx.)
    Connector + −
    Terminal
    M154 21 36 MAIN switch: Pressed 0 Ω
    CANCEL switch: Pressed 250 Ω
    SET− switch: Pressed 660 Ω
    RES+ switch: Pressed 1,480 Ω
    All ASCD steering switches: Released 4,000 Ω

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace ASCD steering switch. Refer to Removal and Installation.

    Admission Valve
    Component Inspection CHECK ADMISSION VALVE-1 With CONSULT Turn ignition switch ON (engine stopped). Perform “ADM/V motor target angle” in “Active Test” mode of “ENGINE...
    Charge Air Cooler Coolant Temperature Sensor
    Component Inspection CHECK CHARGE AIR COOLER (CAC) TEMPERATURE SENSOR Turn ignition switch OFF. Remove CAC coolant temperature sensor. Refer to Exploded View. Check the resistan...

    Other materials:

    Symptom Diagnosis. Moonroof Does Not Operate Properly
    Description Moonroof does not operate normally. Moonroof tilt up/down, open/close does not operate. Moonroof tilt up/down, open/close operation is slow. Judder occurs during open/close operation of moonroof. Diagnosis Procedure CHECK MOONROOF UNIT ASSEMBLY Check the following it ...

    P2122 App Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2122 00 APP SEN 1/CIRC (Throttle/Pedal position sensor/switch D circuit low) Diagnosis condition Engine running at idle Signal (terminal) Accelerator ...

    P0365 Exhaust Camshaft Position Sensor
    DTC Description DTC DETECTION LOGIC Exhaust camshaft position sensor signal is not sent to ECM during engine running. The pulse signal sent from the exhaust camshaft position sensor to ECM is not in the normal pattern during engine running. DTC CONSULT screen terms (Trouble diagnos ...