Nissan Rogue (T33) 2021-Present Service Manual: Charge Air Cooler Coolant Temperature Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Charge Air Cooler Coolant Temperature Sensor

Component Inspection

CHECK CHARGE AIR COOLER (CAC) TEMPERATURE SENSOR

  1. Turn ignition switch OFF.

  2. Remove CAC coolant temperature sensor. Refer to Exploded View.

  3. Check the resistance between CAC coolant temperature sensor terminals under the following conditions.

    Charge air cooler temperature sensor Condition Resistance 
    Terminal
    2 1 Temperature [°C (°F)] 20 (68) 2.37 – 2.63 kΩ
    50 (122) 0.68 – 1.00 kΩ
    90 (194) 0.236 – 0.260 kΩ

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace CAC coolant temperature sensor. Refer to Exploded View.

    Ascd Steering Switch
    Component Inspection CHECK ASCD STEERING SWITCH Turn ignition switch OFF. Disconnect combination switch (spiral cable) harness connector. Check the resistance between combinatio...
    Charge Air Cooler Electric Water Pump Relay
    Component Inspection CHECK ELECTRIC WATER PUMP RELAY Turn ignition switch OFF. Remove electric water pump relay. Check the continuity between electric water pump relay terminals...

    Other materials:

    U215b Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U215B 83 CAN comm err (IPDM E/R) [CAN comm err (IPDM E/R)] Diagnosis condition Ignition switch ON Signal (terminal) CAN communication signal 87 ...

    Main Line Between Strg and Brake Circuit
    Diagnosis Procedure CHECK CONNECTOR Ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector M52 Harness connector B4 ...

    Rear View Monitor. Dtc/circuit Diagnosis
    Power Supply and Ground Circuit Av Control Unit Diagnosis Procedure CHECK FUSE Turn ignition switch OFF. Check that the following fuse is not blown (open) Power source Fuse No. Capacity Battery #25 20 A Is the fuse blown (open)? YES>> Replace fuse after ...