Nissan Rogue (T33) 2021-Present Service Manual: Writing of Calibration Data
Work Procedure
DESCRIPTION
If only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.
WORK PROCEDURE
WRITE CALIBRATION DATA
With CONSULT
-
Select "CALIBRATING CAMERA IMAGE" of "Work Support" mode using CONSULT.
-
After displaying the status, check that the status is displayed as "Normal".
Is the status of each camera displayed as "Normal"?
YES>>INSPECTION END
NO>>Calibrate the camera that is not displayed as "normal". Refer to Work Procedure.
Other materials:
Periodic Maintenance. Brake Fluid
Inspection
BRAKE FLUID LEVEL
Check that the brake fluid level in the reservoir tank is within the standard (between MAX − MIN lines).
Visually check for any brake fluid leakage around the reservoir tank.
Check the brake system for any leakage if the fluid level is extremely low (lo ...
System Description. System
Lithium Ion Battery 12v
System Description
SYSTEM DIAGRAM
Component Function
12V sub battery (lithium ion battery)
Refer to 12V Sub Battery (Lithium Ion Battery).
Combination Meter
Receives li-ion battery error signal from 12V sub battery (lithium ion battery) through IPDM E/R via ...
Intelligent Key System
System Description
SYSTEM DIAGRAM*1: With automatic back door system models*2: Without automatic back door system models Component Function
Outside key antenna
Refer to Outside Key Antenna
Inside key antenna
Refer to Inside Key Antenna
Push-button ignition switch
NATS antenna ...
