Nissan Rogue (T33) 2021-Present Service Manual: Mac Key Writing

Description

When replacing around view monitor control unit, it is necessary to write MAC key to around view monitor control unit. Write MAC key to around view monitor control unit according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.

CAUTION:

During MAC key writing, maintain the following conditions:

  • Ignition switch ON

  • CONSULT is connected to internet

Work Procedure

PERFORM MAC KEY WRITING

  1. Ignition switch ON.

  2. Select "MAC Key writing" on "Work Support" of "AVM" using CONSULT.

  3. Touch "Write".

YES>>

WORK END

    Parameter Writing
    Work Procedure DescriptionWhen replace each camera, it is necessary to write the camera parameters using CONSULT.Write to around view monitor control unit according to "Paramete...
    Writing of Calibration Data
    Work Procedure DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control u...

    Other materials:

    B24a1-16 A/c Auto Amp. Power Supply
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A1-16 A/C AUTO AMP. POWER SUPPLY (Air conditioning automatic amplifier power supply) Diagnosis condition Ignition switch ON Signal (Terminal) Accessory p ...

    Roof rack
    Type A The roof rack system of the Nissan Rogue is designed for use only with properly installed cross bars. Never place any cargo directly on the roof side rails, as cross bars are required to support the load safely and maintain structural balance. The service load capacity of the roof side ra ...

    P0125 Ect Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0125 00 ECT SENSOR (Insufficient coolant temperature for closed loop fuel control) Diagnosis condition — Signal (terminal) Engine coolant temperatur ...