Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Door Does Not Lock/unlock and Engine Does Not Start (all I-Key/req Sw/push Sw)
Description
All doors do not lock/unlock using door request switch and engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| NG | NG | No crank, No start | OK | OK |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
“ENGINE START BY I-KEY” setting in “WORK SUPPORT” mode of “HANDS FREE MODULE” is ON.
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY BATTERY
Check Intelligent Key battery.
Refer to Component Inspection.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials:
P06dc Engine Oil Pressure Control Solenoid Valve
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P06DC
00
Engine oil pressure control
(Engine Oil Pressure Control Circuit High)
Diagnosis condition
Engine running from idle to 4000 rpm
Signal
Engine ...
P04fa Egr Temperature
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P04FA
00
EGR A control
(EGR "A" Control temperature Too High)
Diagnosis condition
—
Signal (terminal)
—
Threshold
ECM detects that a signal ...
Transfer: Ty92a. Service Data and Specifications (sds). Service Data and Specifications (sds)
Service Data and Specifications (sds)
General Specifications
Applied model Axle AWD
Engine KR15DDT
Transaxle CVT
Transfer model
TY92A
Gear ratio
0.404
Number of teeth
Ring gear
42
Drive pinion
17
Oil capacity
Refer to Fluids and Lubricants.
...
