Nissan Rogue (T33) 2021-Present Service Manual: Meter Speaker Signal Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Meter, Warning Lamp & Indicator / Type a :: Dtc/circuit Diagnosis / Meter Speaker Signal Circuit

Diagnosis Procedure

CHECK METER SPEAKER CIRCUIT FOR OPEN

  1. Ignition switch OFF.

  2. Disconnect combination meter harness connector and meter speaker harness connector.

  3. Check the continuity between combination meter harness connector and meter speaker harness connector.

    Combination meter Meter speaker Continuity
    Connector Terminal Connector Terminal

    M73 (U.S.A. production)

    M77 (Japan production)     		3 M83 1 Yes
    4 4

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning parts.

CHECK METER SPEAKER CIRCUIT FOR SHORT TO GROUND

Check the continuity between meter speaker harness connector and ground.

Terminals Continuity
(+) (−)
Meter speaker
Connector Terminal
M83 1 Ground No
4

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace malfunctioning parts.

CHECK METER SPEAKER CIRCUIT FOR SHORT TO POWER SUPPLY

  1. Ignition switch ON.

  2. Check the voltage between meter speaker harness connector and ground.

Terminals

Voltage

(Approx.)
(+) (−)
Meter speaker
Connector Terminal
M83 1 Ground 0 V
4

Is the inspection result normal?

YES>>

Replace meter speaker. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning parts.

    Power Supply and Ground Circuit
    Combination Meter Diagnosis Procedure CHECK FUSES Check that the following fuses are not blown: Unit Location Fuse No. Capacity Combination meter Fuse block (J/B) 29 5A 6 5A Is ...
    Steering Switch Signal a Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check t...

    Other materials:

    Automatic Brake Hold. Removal and Installation
    Chassis Control Module Removal and Installation Removal and installation procedure of chassis control module. Refer to Removal and Installation. Automatic Brake Hold Switch Removal and Installation Removal and installation procedure of parking brake switch. Refer to Removal and Installation.NOTE: ...

    Removal and Installation. Instrument Panel Assembly
    Exploded View 1. Speaker grille RH 2. Instrument garnish 3. Speaker grille LH 4. Instrument panel assembly 5. Instrument mask LH 6. Side ventilator grille assembly LH 7. Instrument pad A 8. Switch bracket B 9. Switch bracket A 10. Inst ...

    Ptc Heater
    Component Function Check CHECK PTC HEATER OPERATION Start the engine. Operate front blower motor. Operate temperature control dial to full hot position. Check for warm air at discharge air outlet. NOTE: Engine must be cold. Battery must be charged. Is the i ...