Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Walk away lock function
When you walk away from the Nissan Rogue with the Intelligent Key, the vehicle will be locked automatically by the walk away lock function (the operation range is around 7 ft (2 m)). This function is disabled by default, but you can enable it using the vehicle information display.
NOTE:
- When the doors are locked by the walk away lock function, the hazard indicator flashes twice. Always confirm that the Nissan Rogue door locks are engaged before you leave the vehicle.
- The walk away lock function may not
operate under the following conditions:
- When any door and/or the liftgate is not securely closed.
- When the engine is running.
- When the Intelligent Key is left inside the vehicle.
- When you place the Intelligent Key outside of the vehicle for a period of time. (When a door is opened and closed, the walk away lock function will be reactivated.)
Approach unlock function
When you approach the Nissan Rogue with the Intelligent Key, the vehicle (all the doors) will unlock automatically by the approach unlock function (the operation range is around 3 ft (1 m)). This function is disabled by default, and you can turn it on through the vehicle information display. When this function is activated, selective unlock is disabled.
NOTE:
- When you approach the vehicle from the front, the approach unlock function may not operate unless you move close to the door itself.
- The approach unlock function may
not operate under the following
conditions:
- When the Intelligent Key is placed inside of the vehicle.
- When you place the Intelligent Key outside of the vehicle for a period of time. (When a door is unlocked and locked, the approach unlock function will be reactivated.)
- When the engine is running (except when the remote engine start function is performed).
- When 8 days have passed since the vehicle was locked.
- When you lock the vehicle with the power door lock switch.
- If the approach unlock function is
activated while the selective unlock
function is turned on, the selective
unlock function is deactivated automatically.
If the selective unlock function is activated while the approach unlock function is turned on, the approach unlock function is deactivated automatically.
Once the approach unlock function is activated, the selective unlock function must be reactivated through the vehicle information display if you want to use the selective unlock function. Both may be turned on depending on the model.
Battery saver system
When all of the following conditions are met for a certain period of time, the Nissan Rogue battery saver system will cut off the power supply to help prevent battery discharge.
- The ignition switch is in the ON position.
Warning lights and audible reminders
To help prevent the Nissan Rogue from moving unexpectedly due to incorrect operation of the Intelligent Key as listed in the following chart, or to help prevent the vehicle from being stolen, a chime or beep will sound inside and outside the vehicle and a warning message will appear on the vehicle information display.
When a chime or beep sounds or a warning message appears, check the vehicle and Intelligent Key status carefully.
Other materials:
P2614 Intake Camshaft Position Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2614
00
A camshaft posi signal B1
(Camshaft A Position Signal Output Circuit/Open Bank 1 )
A
Diagnosis condition
Engine running at idle
Signal (termin ...
Basic Inspection. Additional Service When Replacing Bcm
Description
CAUTION:
When replacing the BCM, always replace it with a new one. The
functions controlled by the BCM may not operate properly in case of
reuse of the BCM from another Nissan Ariya vehicle.
Before pairing of BCM and Intelligent Key unit, always write the BCM
configurati ...
U012e Can Communication
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U012E
00
Communication error (lost)
(Lost communication with camshaft position control module)
Diagnosis condition
Engine running at idle
Signal (terminal)
C ...
