Nissan Rogue (T33) 2021-Present Service Manual: U0416 Can Communication
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| U0416 | 00 |
Invalid data (ABS C/U) (Invalid Data Received From Nissan Ariya Vehicle Dynamics Control Module) |
Diagnosis condition | Ignition switch ON |
| Signal (terminal) | — | |||
| Threshold | When ECM is not receiving invalid CAN data signal of OBD (emission-related diagnosis) with ABS C/U. | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
-
Harness or connectors (CAN communication line is open or shorted.)
-
ABS C/U
FAIL-SAFE
Engine Control System
Not applicable
Stop/Start System
When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.
DTC Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
>>
2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON and wait at least 10 seconds.
-
Check DTC.
Is DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
Perform trouble diagnosis of CAN communication system. Refer to Trouble Diagnosis Flow Chart.
Other materials:
Multi Remote Ent
CONSULT Function (BCM - MULTI REMOTE ENT)
DATA MONITORNOTE:
The following table includes information (items)
inapplicable to this Nissan Ariya vehicle. For information (items)
applicable to this vehicle, refer to CONSULT display items.
Monitor Item Condition
Stop/start switch
[On/Off] ...
Heated Oxygen Sensor 2 Heater
Component Inspection
CHECK HEATED OXYGEN SENSOR 2 HEATER
Turn ignition switch OFF.
Disconnect heated oxygen sensor 2 (HO2S2) harness connector.
Check resistance between HO2S2 terminals as per the following.
Heated oxygen sensor 2 Resistance
Terminal
1
2
5.4 - 7.3 Ω [ ...
P025b Fuel Pump Module a
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P025B
00
FUEL PUMP MODULE A
(Fuel Pump Module "A" Control Circuit Range/Performance)
Diagnosis condition
Engine running
Signal (terminal)
—
Thre ...
