Nissan Rogue (T33) 2021-Present Service Manual: U0422 Can Communication

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / U0422 Can Communication

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
U0422 00

Invalid data (BCM)

(Invalid Data Received From Body Control Module) 		Diagnosis condition Ignition switch ON
Signal (terminal) —
Threshold When ECM is not receiving invalid CAN data signal of OBD (emission-related diagnosis) with BCM.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted.)

  • BCM

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 10 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

Perform trouble diagnosis of CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U0416 Can Communication
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0416 00 Invalid data (ABS C/U) (Invalid Data Received From Niss...
    U042f Can Communication
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U042F 00 Communication error (invalid) (Invalid data received fr...

    Other materials:

    Dtc/circuit Diagnosis. Front Washer Circuit
    Component Function Check CHECK FRONT WASHER OPERATION When the front washer switch is turned to the ON position the front washer should operate. Is front washer operation normal? YES>> Washer switch circuit is normal. NO>> Refer to Diagnosis Procedure. Diagnosis Procedure COMB ...

    P0096 Iat Sensor 2
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0096 00 IAT SENSOR 2 B1 [Intake air temperature sensor 2 circuit range/performance bank 1] Diagnosis condition — Signal (terminal) — Threshol ...

    B2600-42 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-42 Configuration error Diagnosis condition After the ignition switch OFF, wait for 1 minutes or more When ignition switch is ON. Signal (terminal) — Threshold ...