Nissan Rogue (T33) 2021-Present Service Manual: U0402 Can Communication

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / U0402 Can Communication

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
U0402 00

Invalid data (TCM)

(Invalid Data Received From TCM) 		Diagnosis condition Ignition switch ON
Signal (terminal) —
Threshold When ECM is not transmitting or receiving invalid CAN data signal of OBD (emission-related diagnosis) with TCM.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted.)

  • TCM

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 10 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

Perform trouble diagnosis of CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U02bb Can Communication
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U02BB 00 Lost comm with EVAP sys purge pump (Lost comm with ...
    U0416 Can Communication
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0416 00 Invalid data (ABS C/U) (Invalid Data Received From Niss...

    Other materials:

    P1148 Closed Loop Control
    DTC Description DTC DETECTION LOGICNOTE: DTC P1148 is displayed with DTC for A/F sensor 1. When the DTC is detected, perform the trouble diagnosis of DTC corresponding to A/F sensor 1. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1148 00 CLOS ...

    Kr15ddt. Periodic Maintenance. Fuel System
    Fuel System Hydraulic Layout 2WD 1. EVAP line (EVAP canister to EVAP canister purge volume control solenoid valve) 2. Fuel level sensor unit, fuel filter and fuel pump assembly 3. Fuel filler tube 4. Fuel tank 5. EVAP canister 6. Fuel feed line 7. High pr ...

    Main Line Between Hvac and a-Bag Circuit
    Diagnosis Procedure CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harness connectors. A/C amp. Harness connectors M31 and E152 Check the continuity between the ...