Nissan Rogue (T33) 2021-Present Service Manual: Pnsr Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Pnsr Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the power network separate relay for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of power network separate relay.

  2. Check the resistance between the power network separate relay harness connector terminals.

    Power network separate relay harness connector Resistance (Ω)
    Connector No. Terminal No.
    B159 2 3 Approx. 54 – 66

Is the measurement value within the specification?

YES>>

GO TO 3.

NO>>

Repair the power network separate relay branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the power network separate relay. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Present error: Replace the power network separate relay. Refer to Removal and Installation.

YES>>

Past error: Error was detected in the power network separate relay branch line.

NO>>

Repair the power supply and the ground circuit.

    Eps/dast 3 Branch Line Circuit (chasssis Can Communication 1 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...
    Abs Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...

    Other materials:

    Diagnosis System [abs Actuator and Electric Unit (control Unit)]
    CONSULT Function APPLICATION ITEMSCONSULT can display each diagnostic item using the diagnostic test modes as follows. Diagnosis mode CGW Status Description Restricted Mode Diag Test Mode Open Mode Self Diagnosis Result Display Display Display Display non-network DTC which ABS ...

    Symptom Diagnosis. The Braking Force of Parking Brake Is High
    Description The parking brake breaking force is too high. Diagnosis Procedure PERFORM THE SELF DIAGNOSIS RESULT CONSULT Select "Self diagnosis result" mode of "ABS". Is any DTC detected? YES>> Check the DTC. Refer to DTC Index. NO>> GO TO 2. CHECK REAR DISC BRAKE SYSTEM (1) ...

    Symptom Diagnosis. Door Mirror Does Not Operate
    Diagnosis Procedure (Without automatic drive positioner system) CHECK DOOR MIRROR CIRCUIT Check door mirror. Refer to Diagnosis Procedure. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. REPLACE DOOR MIRROR MOTOR Replace door mi ...