Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: The Braking Force of Parking Brake Is High

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Parking Brake System / Symptom Diagnosis :: The Braking Force of Parking Brake Is High

Description

The parking brake breaking force is too high.

Diagnosis Procedure

PERFORM THE SELF DIAGNOSIS RESULT

CONSULT

Select "Self diagnosis result" mode of "ABS".

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 2.

CHECK REAR DISC BRAKE SYSTEM (1)

Check if the rear disc brake is dragging. Refer to Inspection and Adjustment.

Is the rear disc brake dragging?

YES>>

Check the rear disc brake system. Refer to Inspection and Adjustment.

NO>>

GO TO 3.

CHECK REAR DISC BRAKE SYSTEM (2)

  1. Depress the brake pedal 3 times or more.

  2. Drive the Nissan Ariya vehicle at 19 MPH (30 km/h) or more.

  3. Stop the vehicle.

  4. Depress the brake pedal 3 times or more again.

Is the braking force of parking brake is high?

YES>>

Replace the rear brake caliper assembly. Refer to Removal and Installation.

NO>>

Inspection End

    Symptom Diagnosis. The Braking Force of Parking Brake Is Low
    Description The parking brake braking force is low and the vehicle moves backward when parked on an incline. Diagnosis Procedure REAPPLY THE PARKING BRAKE (1) Pull the parking b...
    Removal and Installation. Parking Brake Control
    Exploded View For the rear wheel sensor exploded view. refer to Exploded View.NOTE: The parking brake actuator harness and the rear wheel sensor are a single unit. Removal and I...

    Other materials:

    P2097 A/f Sensor 1
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2097 00 POST CATALYST FUEL TRIM SYS B1 (Post catalyst fuel trim system too rich bank 1) Diagnosis condition — Signal (terminal) Air fuel ratio (A/F) ...

    Vdc Off Indicator Lamp
    Component Function Check CHECK VDC OFF INDICATOR LAMP FUNCTION (1) Check that VDC OFF indicator lamp in combination meter turns ON for approximately 1 second after ignition switch is ON. CAUTION: Never start engine. Is the inspection result normal? YES>> GO TO 2. NO>> Refer ...

    Laser Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). Distance sensor Harness connector B2 ...