Nissan Rogue (T33) 2021-Present Service Manual: Throttle Position Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Throttle Position Sensor

Component Inspection

CHECK THROTTLE POSITION SENSOR

  1. Turn ignition switch OFF.

  2. Reconnect all harness connectors disconnected.

  3. Refer to Work Procedure.

  4. Turn ignition switch ON.

  5. Set selector lever to D position.

  6. Check the voltage between ECM harness connector terminals under the following conditions.

    ECM

    Condition

    		 Voltage
    Connector + −
    Terminal
    F72 57 45 Accelerator pedal Fully released 0.31 V
    Fully depressed 4.47 V
    52 Fully released 4.55 V
    Fully depressed 0.23 V

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace electric throttle control actuator. Refer to Exploded View.

    Throttle Control Motor
    Component Inspection CHECK THROTTLE CONTROL MOTOR Turn ignition switch OFF. Disconnect electric throttle control actuator harness connector. Check the resistance between electri...
    Turbocharger Boost Sensor
    Component Inspection CHECK TURBOCHARGER BOOST SENSOR Turn ignition switch OFF. Remove turbocharger boost sensor with its harness connector. Install pressure pump (A) to turbocha...

    Other materials:

    Propilot Assist 2.1. Ecu Diagnosis Information
    Adas Control Unit 2 List of ECU Reference ECU Reference ADAS control unit 2 Reference Value Fail-safe (ADAS Control Unit) DTC Inspection Priority Chart DTC Index Distance Sensor List of ECU Reference ECU Reference Distance sensor Reference Value Fail-safe ...

    Symptom Diagnosis. Heated Steering Wheel System Does Not Activate
    Description The heated steering wheel does not warm up. The heated steering wheel system cannot be turned OFF. Diagnosis Procedure PERFORM SELF DIAGNOSTIC RESULT CONSULT Ignition switch ON. Select “Self Diagnostic Result” mode of “HVAC”. Check DTC. Is DT ...

    Service After Replacing or Removing Engine Parts
    Description X: Applicable Part name Service performed Required service Reference Replacement Removal   ECM X — Additional service when replacing ECM Work Procedure Fuel injector offset learning Work Procedure Turbocharger wastegate control solenoid valve d ...