Nissan Rogue (T33) 2021-Present Service Manual: System Description :: Diagnosis System (electrically-Driven Intelligent Brake Unit). Consult Function
Consult Function
Diagnosis Description
APPLICATION ITEM
CONSULT can display each diagnostic item using the diagnostic test modes as follows.
| Diagnosis mode | Note |
|---|---|
| Self Diagnostic Result | Display DTC which Electrically-driven Intelligent Brake Unit memorizes |
| Data monitor | Displays Electrically-driven Intelligent Brake Unit input/output data in real time |
| Active test | Enables an operational check of a load by transmitting a driving signal from the Electrically-driven Intelligent Brake Unit to the load |
| ECU Identification | Displays Electrically-driven Intelligent Brake Unit part number |
| Replace ECU | Write the Nissan Ariya vehicle specification when replacing Electrically-driven Intelligent Brake Unit |
SELF DIAGNOSTIC RESULT
Refer to DTC Index.
When “CRNT” is displayed on self-diagnosis result
-
The system is presently malfunctioning.
When “PAST” is displayed on self-diagnosis result
-
System malfunction in the past is detected, but the system is presently normal.
Freeze frame data (FFD)
When DTC is detected, a vehicle state shown below is recorded and displayed on CONSULT.
| Item | Unit | Description |
|---|---|---|
| Error code | — | Displays but not used. |
| ODO/TRIP meter | km | Displays the total mileage (Odometer value) of the moment a particular. |
| DTC count | — | Displays the number of times DTC is detected. |
DATA MONITOR
NOTE:
-
The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
-
Perform all self-diagnosis and delete stored DTC after execute Data monitor.
| Item | Unit | Note |
|---|---|---|
| Input rod position | mm | Displays the input rod position. |
| Output rod position | mm | Displays the output rod position. |
| Temperature 1 | ℃ | Display the control unit temperature of Electrically-driven Intelligent Brake Unit. |
| Temperature 2 | ℃ | Display the control unit temperature of Electrically-driven Intelligent Brake Unit. |
| Battery voltage | V | Displays the 12V battert power supply voltage value applied to Electrically-driven Intelligent Brake Unit. |
| Control module voltage | mV | Displays the Ignition switch ON power supply voltage value applied to Electrically-driven Intelligent Brake Unit. |
| Stroke sensor | V | Displays the output voltage of stroke sensor. |
| Front LH wheel speed | — | Displays but not used. |
| Front RH wheel speed | — | Displays but not used. |
| Rear LH wheel speed | — | Displays but not used. |
| Rear RH wheel speed | — | Displays but not used. |
| Nissan Ariya Vehicle speed 1 | — | Displays but not used. |
| Forward / backward judgment | — | Displays but not used. |
| Backup power supply volt | V | Displays the power supply voltage value applied to brake power supply backup unit. |
| Odometer | m | Displays the mileage. |
| Wheel speed 1 | kph | Displays the wheel speed of drive wheel. |
| Wheel speed 2 | kph | Displys the wheel speed of passive wheel. |
| Brake fluid pressure | Mpa | Displays the brake fluid pressure. |
| External brake request | 1 / 2 / 3 / 4 | Displays the request status of except driver brake. |
ACTIVE TEST
The active test is used to determine and identify details of a malfunction, based on self-diagnosis test result and data obtained in the Data monitor. In response to instructions from CONSULT, instead of those from Electrically-driven Intelligent Brake Unit on the Nissan Ariya vehicle, a drive signal is sent to the actuator to check its operation.
CAUTION:
-
Never perform Active test while driving the vehicle.
-
Always bleed air from brake system before active test.
-
Never perform active test when system is malfunctioning.
NOTE:
-
When performing active test again after “TEST IS STOPPED” is displayed, select “BACK”.
-
Brake warning lamp and brake system warning lamp may turn ON during active test. This is not a malfunction.
-
Perform all self-diagnosis and delete stored DTC after execute Active test.
Warning Buzzer
| Item | Note |
|---|---|
| Buzzer | Activate the buzzer. |
ECU IDENTIFICATION
Electrically-driven Intelligent Brake Unit part number can be read.
REPLACE ECU
Write the vehicle specification when replacing Electrically-driven Intelligent Brake Unit.
Other materials:
Cockpit
Steering Assist switch* (models with ProPILOT Assist) — activates steering support features available on the Nissan Rogue.*
Head Up Display (HUD) switch* — controls the HUD system that projects key driving information onto the windshield.*
Headlight and turn signal switch — operates ...
Front Drive Shaft Boot (kr15ddt)
Exploded View
LEFT SIDE
Circular clip
Dust shield
Housing
Snap ring
Spider assembly
Stopper ring
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circular clip
Joint sub-assembly
Dust shield
: Wheel s ...
Fonctionnement du système BSW
Témoin lumineux latéral
Témoin BSW (sur l'écran d'informations du véhicule)
Écran d'informations du véhicule
Commandes au volant (côté gauche)
Le système d’avertissement d’angle mort (BSW) du Nissan Rogue fonctionne lorsque la vitesse du véhicule dépasse environ 32 ...
