Nissan Rogue (T33) 2021-Present Service Manual: P11a0 Vcr Control Module
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P11A0 | 00 |
VCR control module (Variable compression ratio control module) |
Diagnosis condition | — |
| Signal (terminal) | — | |||
| Threshold | Malfunction in VCR control module processor | |||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
-
VCR control module
FAIL-SAFE
Not applicable
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 12 V or more with ignition switch ON.
YES>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON and wait at least 10 seconds.
-
Check 1st trip DTC.
Is DTC P11A0 detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure. DTC Description
Is the DTC P11A0 displayed again?
YES>>Replace VCR control module. Refer to VCR CONTROL MODULE : Removal & Installation.
NO>>INSPECTION END
Other materials:
P044c Egr Volume Control Valve Position Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P044C
00
EGR SENSOR C
(EGR sensor C circuit low)
Diagnosis condition
Ignition switch ON
Signal (terminal)
EGR volume control valve signal
Threshol ...
C10af-01 Pressure Sensor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C10AF
01
Pressure sensor
(Pressure sensor)
Diagnosis condition
During driving below 15 km/h (9.4 MPH) (no braking)
When the power supply voltage is nor ...
Main Line Between Hvac and a-Bag Circuit
Diagnosis Procedure
CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect the following harness connectors.
A/C amp.
Harness connectors M31 and E152
Check the continuity between the ...
