Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Srs Air Bag Warning Lamp Does Not Turn Off
Diagnosis Procedure
CHECK 12V BATTERY
Check 12V battery. Refer to Work Flow.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning parts.
CHECK AIR BAG FUSE
Check 10 A fuse [No. 7, located in fuse block (J/B)].
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace the fuse.
PERFORM ZERO POINT RESET
-
Perform zero point reset. Refer to Description.
-
Check SRS air bag warning lamp operation.
Is the inspection result normal?
YES>>Inspection End
NO>>GO TO 4.
CHECK DTC WITH AIR BAG DIAGNOSIS SENSOR UNIT
Check that DTC is not detected with air bag diagnosis sensor unit.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Refer to DTC Index.
CHECK DTC WITH COMBINATION METER
Check that DTC is not detected with combination meter.
Is the inspection result normal?
YES>>GO TO 6.
NO>>Refer to DTC Index (Type A meter) or DTC Index (Type B meter).
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Check SRS air bag warning lamp operation.
Is the inspection result normal?
YES>>Inspection End
NO>>GO TO 7.
REPLACE COMBINATION METER
-
Replace combination meter. Refer to Removal and Installation (Type A meter) or Removal and Installation (Type B meter).
-
Check SRS air bag warning lamp operation.
Is the inspection result normal?
YES>>Inspection End
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials:
Témoin d'avertissement et témoin sonore de ceinture de sécurité
Le témoin lumineux et le témoin sonore
vous rappellent d'attacher les ceintures
de sécurité du conducteur, du passager
avant et du passager arrière. Une alerte
visuelle et sonore fonctionnera dans les
conditions suivantes :
La ceinture de sécurité du conducteur
n'est pas at ...
P15b0 Sub Starter & Generator
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P15B0
00
Sub starter & generator
(Sub starter & generator)
Diagnosis condition
—
Signal (terminal)
—
Threshold
When ECM detects an ...
Low Pressure Fuel Pump
Component Function Check
CHECK LOW PRESSURE FUEL PUMP FUNCTION
Turn ignition switch ON.
Pinch fuel feed hose with two fingers.
Fuel pressure pulsation should be felt on the fuel feed hose for 1 second after ignition switch is turned ON.
Is the inspection result normal?
YES ...
