Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Take Away Warning Does Not Operate

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Symptom Diagnosis :: Take Away Warning Does Not Operate

Diagnosis Procedure

CHECK COMBINATION METER BUZZER

Check combination meter buzzer.

Refer to Diagnosis Procedure (Full TFT meter) or Diagnosis Procedure (7 inch information display).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the malfunctioning parts.

CHECK INFORMATION DISPLAY

Check information display.

Refer to Work flow.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace the malfunctioning parts.

CHECK DOOR SWITCH

Check door switch.

Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace the malfunctioning parts.

CHECK INTELLIGENT KEY WARNING BUZZER

Check Intelligent Key warning buzzer.

Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair or replace the malfunctioning parts.

CHECK INSIDE KEY ANTENNA

Check inside key antenna.

  • NATS antenna amp.: Refer to DTC Diagnosis Procedure.

  • Inside key antenna: Refer to DTC Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 6.

NO>>

Repair or replace the malfunctioning parts.

REPLACE INTELLIGENT KEY UNIT

  1. Replace Intelligent Key unit. Refer to Removal and Installation.

  2. Confirm the operation after replacement.

Is the result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident

    Symptom Diagnosis. Reminder Function Does Not Operate
    Door Request Switch Description Reminder function does not operate using door request switch. Diagnosis Procedure CHECK “ANSWER BACK” SETTING IN “WORK SUPPORTS” CONSULT ...
    Symptom Diagnosis. Vehicle Speed Sensing Auto Lock Operation Does Not Operate
    Diagnosis Procedure REPLACE BCM Replace BCM. Refer to Removal and Installation. Confirm the operation after replacement. Is the result normal? YES>> Inspection End. NO>...

    Other materials:

    Removal and Installation. Automatic Back Door Warning Buzzer
    Removal and Installation REMOVALFOR USA AND JAPAN EARLY PRODUCTION AND USA LATE PRODUCTIONRemove rear bumper fascia. Refer to Removal and Installation. Remove the automatic back door warning buzzer mounting nuts (A), and then remove automatic back door warning buzzer (1). INSTALLATIONInstallala ...

    Knock Sensor
    Component Inspection CHECK KNOCK SENSOR Turn ignition switch OFF. Disconnect knock sensor harness connector. Check resistance between knock sensor terminals as follows. NOTE: It is necessary to use an ohmmeter which can measure more than 10 MΩ. Knock sensor Condition Re ...

    P0446 Evap Canister Vent Control Valve
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0446 00 VENT CONTROL VALVE (EVAP System Vent Control Circuit) Diagnosis condition Engine running at idle Signal (terminal) EVAP canister vent control ...