Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Low Tire Pressure Warning Lamp Does Not Turn on

Nissan Rogue (T33) 2021-Present Service Manual / Suspension :: Road Wheels & Tires / Symptom Diagnosis :: Low Tire Pressure Warning Lamp Does Not Turn on

Description

The low tire pressure warning lamp does not turn ON when the ignition switch is placed ON.

NOTE:

The low tire pressure warning lamp turn ON for approximately 1 second and then turns OFF when the ignition switch is placed ON. This is to check that no abnormal condition is present in the tire pressure monitoring system.

The combination meter may be malfunctioning or the tire pressure monitoring system may be malfunctioning if the low tire pressure warning lamp does not turn ON when the ignition switch is placed ON.

Diagnosis Procedure

NOTE:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

CHECK TIRE PRESSURE

  1. Ignition switch ON.

    CAUTION:

    Never start the engine.

  2. Check the tire pressure for all wheels and adjust to the specified value. Refer to Tire Air Pressure.

  3. Recheck the tire pressure for all wheels. Refer to Tire Air Pressure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Inspect or repair the tires or wheels.

CHECK LOW TIRE PRESSURE WARNING LAMP OPERATION

Check low tire pressure warning lamp display.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

GO TO 3.

PERFORM SELF-DIAGNOSIS

CONSULT

Perform “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Perform DTC diagnosis procedure. Refer to DTC Index.

NO>>

GO TO 4.

CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace error-detected parts.

    Symptom Diagnosis. Tire Pressure Monitoring System Symptom
    Symptom Table LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART Diagnosis items Symptom (Ignition switch ON) Low tire pressure warning lamp Cause Action Low tire pressure warning lam...
    Symptom Diagnosis. Low Tire Pressure Warning Lamp Does Not Turn Off
    Description The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts. Diagnosis Procedure CHECK TIRE PRESSURE Ignition switch ON....

    Other materials:

    P2239 Ho2s2
    DTC Description To judge malfunctions, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal fluctuates according to fuel feedback control.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2239 00 ...

    U2384 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2384 83 CAN comm err (eVTC) [CAN comm err (eVTC)] Diagnosis condition Ignition switch ON Signal (terminal) CAN communication signal 87 Thresho ...

    Repair Information. Preparation
    Repairing Material Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Ariya vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially availabl ...