Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Low Tire Pressure Warning Lamp Does Not Turn Off
Description
The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts.
Diagnosis Procedure
CHECK TIRE PRESSURE
-
Ignition switch ON.
CAUTION:
Never start the engine.
-
Check the tire pressure for all wheels and adjust to the specified value. Refer to Inspection.
-
Recheck the tire pressure for all wheels. Refer to Inspection.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Inspect or repair the tires or wheels.
CHECK LOW TIRE PRESSURE WARNING LAMP OPERATION
Check low tire pressure warning lamp display.
Is the inspection result normal?
YES>>Inspection End.
NO>>GO TO 3.
PERFORM SELF DIAGNOSIS
CONSULT
Perform “Self diagnosis result” mode of “BCM”.
Is DTC detected?
YES>>Perform DTC diagnosis procedure. Refer to DTC Index.
NO>>GO TO 4.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Repair or replace error-detected parts.
Other materials:
P2297 Air Fuel Ratio Sensor 1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2297
00
O2 SENSOR 1 B1
(O2 Sensor Out of Range During Deceleration Bank 1 Sensor 1)
Diagnosis condition
Engine run and fuel shut off
Signal
A/F sensor ...
Dtc/circuit Diagnosis. U3d01-51 Fota
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
U3D01-51
FOTA
(FOTA)
Diagnosis condition
Ignition switch is ON.
Signal (terminal)
BCM (CPU).
Threshold
When a CPU functional abnormality is detected ...
Dtc/circuit Diagnosis. Interior Room Lamp Power Supply Circuit
Diagnosis Procedure
Provides the interior room lamp power supply. Also cuts the power
supply when the interior room lamp battery saver is activating.CHECK INTERIOR ROOM LAMP POWER SUPPLY FUSE
Ignition switch OFF.
Check that the following fuse is not blown (open):
Signal name Location ...
