Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Low Tire Pressure Warning Lamp Blinks

Description

When the ignition switch is placed ON, the low tire pressure warning lamp blinks. And then 1 minute later, low tire pressure warning lamp turns ON.

Diagnosis Procedure

CHECK TIRE PRESSURE SENSOR INSTALLATION

Check visually that tire pressure sensors are installed to each wheels correctly.

NOTE:

In the following case, TPMS does not function.

Are the genuine NISSAN tire pressure sensors are installed correctly?

GO TO 2.

Replace and/or Install tire pressure sensor(s).Refer to Removal & Installation. GO TO 3.

PERFORM SELF DIAGNOSIS RESULT

CONSULT

Perform “Self diagnosis result” mode of “BCM”.

Is DTC detected?

Perform DTC diagnosis procedure. Refer to DTC Index.

GO TO 4.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Description.

Is tire pressure sensor ID registration completed?

Adjust the tire pressure for all wheels specified to the value. Refer to Inspection. Inspection End.

Perform diagnosis procedure of “TIRE PRESSURE SENSOR ID REGISTRATION CANNOT BE COMPLETED”. Refer to Description.

CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for BCM power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

Repair or replace error-detected parts.

Replace BCM. Refer to Removal and Installation.