Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Low Tire Pressure Location Indicator Does Not Display

Nissan Rogue (T33) 2021-Present Service Manual / Suspension :: Road Wheels & Tires / Symptom Diagnosis :: Low Tire Pressure Location Indicator Does Not Display

Description

When low tire pressure, low tire location indicator does not display though low tire pressure warning lamp turns ON.

Diagnosis Procedure

CHECK COMBINATION METER

Check combination meter. Refer to the following.

  • Type A meter: Work flow

  • Type B meter: Work flow

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

CHECK LOW TIRE PRESSURE WHEEL LOCATION INDICATOR OPERATION

Check that the low tire pressure location indicator is turned OFF after turns ON for approximately 1 second, when the ignition switch is placed ON.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Replace the BCM. Refer to Removal and Installation.

    Symptom Diagnosis. Low Tire Pressure Warning Lamp Blinks
    Description When the ignition switch is placed ON, the low tire pressure warning lamp blinks. And then 1 minute later, low tire pressure warning lamp turns ON. Diagnosis Procedu...
    Symptom Diagnosis. Low Tire Pressure Location Indicator Continues Displaying
    Description The low tire pressure location indicator continues displaying though low tire pressure warning lamp turns/stays OFF. Diagnosis Procedure CHECK TIRE PRESSURE Ignition...

    Other materials:

    P2b95 Cold Start Control
    DTC Description ECM controls fuel injection timing and fuel injection quantity when engine is started with the engine cold.This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis co ...

    Vacuum Pump
    Exploded View Vacuum pump         Comply with the assembly procedure when tightening. Refer to Removal and Installation.         : Sealing point : N·m (kg-m, in-lb) Removal and Installation REMOVALRemove air duct. Ref ...

    Dtc/circuit Diagnosis. Back Door Opener Actuator
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Trunk/back door” in “Active test” mode of "BCM". Check that the function operates normally according to the following conditions. Monitor item Status Trunk/back door On Back door OPEN ...