Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Low Tire Pressure Location Indicator Continues Displaying
Description
The low tire pressure location indicator continues displaying though low tire pressure warning lamp turns/stays OFF.
Diagnosis Procedure
CHECK TIRE PRESSURE
-
Ignition switch ON.
CAUTION:
Never start the engine.
-
Check the tire pressure for all wheels and adjust to the specified value. Refer to Inspection.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Inspect or repair the tires or wheels.
CHECK LOW TIRE PRESSURE LOCATION INDICATOR
Check low tire pressure location indicator.
Does low tire pressure location indicator continues displaying?
YES>>GO TO 3.
NO>>Inspection End.
PERFORM SELF DIAGNOSIS RESULT
CONSULT
Select “Self diagnosis result� mode of “BCM�.
Is DTC detected?
YES>>Perform DTC diagnosis procedure. Refer to DTC Index.
NO>>GO TO 4.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Repair or replace error-detected parts.
Other materials:
Side Radar (front Right) (side Radar Front Rh)
C1ec0-44 Control Unit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
C1EC0
44
Control unit
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
—
Threshold
If side radar front RH ...
Engine. Starting System
Precaution :: Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG� and “SEAT BELT
PRE-TENSIONER�, used along with a front seat belt, helps to reduce the
risk or severity of injury to t ...
Laser Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
Distance sensor
Harness connector B2 ...
