Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Back Door Auto Closure Function Does Not Operate
Diagnosis Procedure
CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT
Check that DTC is not detected with automatic back door control unit.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Refer to DTC Index.
CHECK OPEN SWITCH
Check open switch.
Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CHECK CLOSE SWITCH
Check close switch.
Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the malfunctioning parts.
CHECK HALF LATCH SWITCH
Check half latch switch.
Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair or replace the malfunctioning parts.
CHECK BACK DOOR CLOSURE MOTOR
Check back door closure motor.
Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 6.
NO>>Repair or replace the malfunctioning parts.
REPLACE BACK DOOR LOCK ASSEMBLY
-
Replace back door lock assembly.
-
Confirm the operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>GO TO 7.
REPLACE AUTOMATIC BACK DOOR CONTROL UNIT
-
Replace automatic back door control unit. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials:
Seat belt warning light and chime
The seat belt warning light and chime remind the occupants of the Nissan Rogue to fasten the driver, front passenger, and rear passenger seat belts. A visual and audible alert activates under the following conditions:
The driver’s seat belt is not fastened.
The front passenger’s seat b ...
P1538 Ascd System
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P1538
00
Cruise control
(Cruise control)
Diagnosis condition
Ignition switch ON
Signal
CAN communication signal
Threshold
ECM cannot receive a ...
Writing of Calibration Data
Work Procedure
DESCRIPTIONIf only the around view monitor control unit
is replaced, the calibration data stored in the camera can be written
to the around view monitor control unit by selecting "Camera
Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA
With C ...
