Nissan Rogue (T33) 2021-Present Service Manual: P1538 Ascd System

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P1538 00

Cruise control

(Cruise control)
Diagnosis condition Ignition switch ON
Signal CAN communication signal
Threshold

ECM cannot receive a communication signal sent from the TCM (transmission control module).

Internal error of the TCM (Transmission control module) is detected.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (The CAN communication line is open or shorted.)

  • TCM (Transmission control module)

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 3 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    P1536 Ascd System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1536 00 Cruise control (Cruise control) Diagnosis condition Ign...
    P155b Energy Management Control
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P155B 00 Electrical energy management system (Electrical energy ...

    Other materials:

    Dtc/circuit Diagnosis. Mood Lamp Control Circuit
    Component Function Check CAUTION: Before performing the diagnosis, check that the following are normal: Interior room lamp power supply circuit Mood lamp (center console) bulb (with ambient lighting) CHECK MOOD LAMP OPERATION CONSULT Open the front door LH. Ignition switc ...

    B2600-46 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-46 Configuration error Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold Errors are detected in the programming data stored in the 8CH CAN gatewa ...

    B2202-11 Fuel Sender
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2202-11 Fuel level sensor (Fuel level sensor) Diagnosis condition When ignition switch is ON. Signal (terminal) Fuel level sensor signal Threshold S ...