Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Auto Door Lock Operation Does Not Operate

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Symptom Diagnosis :: Auto Door Lock Operation Does Not Operate

Diagnosis Procedure

REPLACE INTELLIGENT KEY UNIT

  1. Replace Intelligent Key unit. Refer to Removal and Installation.

  2. Confirm the operation after replacement.

Is the result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

    Symptom Diagnosis. Automatic Back Door Anti-Pinch Function Does Not Operate
    Diagnosis Procedure CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT Check that DTC is not detected with automatic back door control unit. Is the inspection result normal? YES>...
    Symptom Diagnosis. Back Door Auto Closure Function Does Not Operate
    Diagnosis Procedure CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT Check that DTC is not detected with automatic back door control unit. Is the inspection result normal? YES>...

    Other materials:

    Evtc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the electric intake valve timing control module for damage, bend and loose connection (unit side and connector side). ...

    C1f80-88 Steering Wheel Touch Sensor
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F80 88 Steering wheel touch sensor (Steering wheel touch sensor) Diagnosis condition When engine is running Signal (terminal) ...

    Basic Inspection. Additional Service When Replacing Automatic Back Door Control Unit
    Description When replacing automatic back door control unit necessary to perform initial setting to operate automatic back door system normally. Refer to Work Procedure. Work Procedure STEP 1 CONSULT Select “Reset auto back door status” in “Work supports” mode of "AUTOMATIC BACK ...