Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Approach Unlock/walk Away Lock Function Does Not Operate (all Keys)
Description
Approach unlock/walk away lock function does not operate.
NOTE:
Before starting diagnosis check that vehicle condition is as shown in "Conditions of Nissan Ariya vehicle", and check each symptom.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOM)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| Poor range | OK | OK | OK | NG |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
-
"Walk Away Lock" and "Apporach Unlock" of the vehicle setting in the combination meter is ON.
-
Registered Intelligent Key is witing the detection area of outside key antenna.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK OUTSIDE KEY ANTENNA
Check outside key antenna.
-
Rear door RH: Refer to DTC Diagnosis Procedure.
-
Rear door LH: Refer to DTC Diagnosis Procedure.
-
Rear bumper: Refer to DTC Diagnosis Procedure.
Is the Insepection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>Check intermittent incident.Refer to Intermittent Incident.
Other materials:
Awd. Preparation. Preparation
Preparation
Special Service Tool
Tool number
Tool name Description
KV40104000
Hub lock nut wrench
a: 85 mm (3.35 in)
b: 65 mm (2.56 in)
Removing and Installing wheel hub lock nut.
KV40107310
Boot band crimping tool
Installing boot band
KV40107300
Boot ban ...
On Board Diagnostic (obd) System
Description
This is an on board diagnosis system which records diagnosis
information related to the exhaust gases. It detects malfunctions
related to sensors and actuators. The malfunctions are indicated by
means of the malfunction indicator lamp (MIL) and are stored as DTC in
the ECU memor ...
Side Radar (rear Right) (side Radar Rear Rh)
C1e80-44 Control Unit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1E80–44
Control unit
(Control unit)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
-
Threshold
If sid ...
