Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Rain-sensing auto wiper system
The rain-sensing auto wiper system automatically activates and adjusts wiper speed based on rainfall and vehicle speed. The rain sensor is located near the top of the windshield in the Nissan Rogue.
To enable the system, push the lever down to AUTO position 1. The wiper will sweep once with the ignition ON.
The sensitivity level can be adjusted by turning the knob toward 2 (Low) or (High):
- High — higher sensitivity
- Low — lower sensitivity
To turn the rain-sensing system off, push the lever up to OFF, or move it down to another position.
NOTE:
The rain sensor may be disabled.
CAUTION
Do not touch the rain sensor when the switch is in AUTO and the ignition is ON, as the wipers may activate unexpectedly.
- The rain-sensing system is intended for rainfall use. If left in AUTO, wipers may activate when dirt, fingerprints, insects, exhaust gas, or moisture affect the sensor.
- If the windshield has a water-repellent coating, the wiper speed may increase even with light rain.
- Turn off the rain-sensing system before using a car wash.
- The system may not activate if rainwater does not reach the sensor area.
- Using genuine wiper blades is recommended to maintain proper operation of the Nissan Rogue rain-sensing system.
Basic information
WARNING
In freezing temperatures, the washer solution may freeze on the windshield and limit visibility, increasing the risk of an accident. Warm the windshield with the defroster before using the was ...
Rear window wiper and washer operation
WARNING
In freezing temperatures, the washer solution may freeze on the rear window and reduce visibility. Warm the glass with the defroster before using the washer.
CAUTION
Do not operate the wash ...
Other materials:
Removal and installation
BCM (BODY CONTROL MODULE)
Removal and Installation
CAUTION:
Before replacing the BCM, perform “READ CONFIGURATION” to save or print current
vehicle specification.
Refer to BCS-60, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work
Procedure".
REMOVAL
Disco ...
Battery
Keep the battery surface clean and dry.
Clean the battery with a solution of baking
soda and water.
Make certain the terminal connections are
clean and securely tightened.
If the vehicle is not to be used for 30 days or
longer, disconnect the negative (-) battery
termina ...
Intercooler cooling system
Basic information
The intercooler cooling circuit of the Nissan Rogue is factory-filled with a 50/50 mixture of Genuine NISSAN Long Life Antifreeze/Coolant (blue) and water. This blend protects the system all year and includes corrosion inhibitors.
No extra additives are required for the intercool ...
