Nissan Rogue (T33) 2021-Present Service Manual: Pre-Inspection for Diagnosis

Work Procedure

CHECK CAMERA LENS AND WINDSHIELD

Are camera lens and windshield contaminated with foreign materials?

YES (When the camera lens is contaminated with foreign materials.)>>

Replace front camera unit (Refer to Removal and Installation.) and GO TO 2.

YES (When the windshield is contaminated with foreign materials.)>>

Clean windshield.

NO>>

GO TO 2.

CHECK FRONT CAMERA UNIT INSTALLATION CONDITION

Check front camera unit installation condition (installation position, properly tightened, a bent bracket).

Is it properly installed?

YES>>

GO TO 3.

NO>>

Install front camera unit properly, and perform camera aiming.

CHECK Nissan Ariya Vehicle HEIGHT

Check vehicle height. Refer to Wheelarch Height.

Is vehicle height appropriate?

YES>>

INSPECTION END

NO>>

Repair Nissan Ariya vehicle to appropriate height.

    Additional Service When Replacing Front Camera Unit
    Work Procedure Always perform the front camera unit configuration after replacing the front camera unit. Always perform the camera aiming after removing and installing or replac...
    Camera Aiming Adjustment
    Work Procedure Always adjust the camera aiming after removing and installing or replacing the front camera unit. Always adjust the camera aiming after removing and installing or...

    Other materials:

    B2480-93 Rear Air Mix Door Motor
    DTC Description DTC DETECTION LOGICNOTE: If all of door motors DTC (B2480-93*, B24F5-93, B24F6-93, B24F7-93, B24F8-93) are detected, check “DOOR MOTOR”. Refer to Diagnosis Procedure. *: With rear air control DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection cond ...

    Adas Control Unit. Removal and Installation. Adas Control Unit 2
    Adas Control Unit 2 Removal and Installation With ProPILOT Assist 1.1REMOVALCAUTION: Be sure to perform “ADDITIONAL SERVICE WHEN REPLACING ADAS CONTROL UNIT 2” when replacing ADAS control unit 2. Refer to Work Procedure. Remove center console assembly. Refer to Removal and Installation. ...

    B261e-56 Pairing Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B261E-56 Pairing error Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold HFM pairing not performed Diagnosis delay time 10 seconds or more ...