Nissan Rogue (T33) 2021-Present Service Manual: Power Supply and Ground Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Cruise Control System / Propilot Assist 2.1 :: Dtc Diagnosis / Power Supply and Ground Circuit

Power Supply and Ground Circuit (hd Map Module)

Diagnosis Procedure

CHECK FUSE

Check if the following fuses are blown.

Power supply Fuse No.
Ignition 113
Battery 111

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the part that caused blown fuse, and then replace fuse with new one.

CHECK POWER SUPPLY CIRCUIT OF HD MAP MODULE

Check voltage between Nissan Ariya vehicle side harness connector of HD map module and ground.

Probe Measurement condition Voltage
(+) (–)
HD map module Ground Ignition SW
Connector Terminal
B131 3 OFF 0 V
ON Power supply voltage
13 OFF Power supply voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair power supply circuit of HD map module.

CHECK GROUND CIRCUIT OF HD MAP MODULE

  1. Turn ignition switch OFF.

  2. Disconnect connector of HD map module.

  3. Check continuity between Nissan Ariya vehicle side harness connector of HD map module and ground.

    HD map module Ground Continuity
    Connector Terminal
    B131 1 Exist
    16

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair ground circuit of HD map module.

Power Supply and Ground Circuit (power Network Separate Relay)

Diagnosis Procedure

CHECK FUSE

Check if the following fuses are blown.

Power supply Fuse No.
Ignition 9

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the part that caused blown fuse, and then replace fuse with new one.

CHECK POWER SUPPLY CIRCUIT OF POWER NETWORK SEPARATE RELAY

Check voltage between Nissan Ariya vehicle side harness connector of power network separate relay and ground.

Probe Measurement condition Voltage
(+) (–)
Power network separate relay Ground Ignition SW
Connector Terminal
B159 4 OFF 0 V
ON Power supply voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair power supply circuit of power network separate relay.

CHECK GROUND CIRCUIT OF POWER NETWORK SEPARATE RELAY

  1. Turn ignition switch OFF.

  2. Disconnect connector of power network separate relay.

  3. Check continuity between Nissan Ariya vehicle side harness connector of power network separate relay and ground.

    Power network separate relay Ground Continuity
    Connector Terminal
    B159 1 Exist

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair ground circuit of power network separate relay.

    Pns Relay (power Network Separate Relay)
    B23c0-04 Power Network Separate Relay DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition B23C0 04 Power network separate relay Diagnosis condit...
    Propilot Assist 2.1. Symptom Diagnosis. Propilot Assist 2.1
    Propilot Assist 2.1 Propilot Assist 2.0 System Symptoms Symptom Table Check whether symptom is due to normal operation before performing diagnosis. Refer to Precautions for ProP...

    Other materials:

    P11b0 Vcr Target Angle (cold Start)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11B0 00 VCR target angle (cold start) [Variable compression ratio target angle (cold start)] Diagnosis condition Engine cold start Signal (terminal) ...

    Air cleaner
    To remove the filter on the Nissan Rogue, release the lock pins 1 and pull the unit upward 2. The viscous paper filter element (if equipped) is not designed to be cleaned and reused. The dry paper type element may be cleaned and reused when its condition allows. Replace the filter according ...

    Back-Up Lamp Circuit
    Component Function Check CHECK BACK-UP LAMP OPERATION Start the engine. With operating the shift selector, check that the back-up lamp is turned ON. Shift selector position: R range : Back-up lamp ON Shift selector position: Other than above : Back-up lamp OFF Is th ...