Nissan Rogue (T33) 2021-Present Service Manual: P15b1 Sub Starter & Generator
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P15B1 | 00 |
Sub starter & generator (Sub starter & generator) |
Diagnosis condition | — |
| Signal (terminal) | — | |||
| Threshold | When ECM detects an abnormal signal (driving function abnormality) of sub starter & generator. | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
-
Sub starter & generator
-
Harness or connectors
(Sub starter & generator circuit is open or shorted.)
FAIL-SAFE
Not applicable
Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
>>
GO TO 2.
CHECK DTC PRIORITY
-
Start the engine and drive until the operating conditions of the stop/start system are met.
-
After stepping on the brake to stop the Nissan Ariya vehicle and activating the stop/start system, release the brake and restart.
-
Check DTC.
Is DTC P15B1 detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK DTC WITH SUB STARTER & GENERATOR
Check DTC with sub starter & generator. Refer to DTC Index.
Is DTC detected?
YES>>Perform trouble shooting relevant to DTC indicated.
NO>>INSPECTION END
Other materials:
P0446 Evap Canister Vent Control Valve
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0446
00
VENT CONTROL VALVE
(EVAP System Vent Control Circuit)
Diagnosis condition
Engine running at idle
Signal (terminal)
EVAP canister vent control ...
Power Socket. Removal and Installation. Power Socket
Power Socket
Console Power Socket
Removal and Installation
REMOVALRemove switch panel. Refer to Removal and Installation.
Press the power socket fixing pawls from the back of the switch panel to remove the power socket.
: Pawl
INSTALLATIONNote the following, and install in the reve ...
Action Test
Ldw
Work Procedure
Perform action test to verify the customer's concern.
Perform action test and check the system operation after system diagnosis.
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Fully understand the ...
