Nissan Rogue (T33) 2021-Present Service Manual: P15b0 Sub Starter & Generator
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P15B0 | 00 |
Sub starter & generator (Sub starter & generator) |
Diagnosis condition | — |
| Signal (terminal) | — | |||
| Threshold | When ECM detects an abnormal signal (power generation function abnormality) of sub starter & generator. | |||
| Diagnosis delay time | 179 seconds or more | |||
POSSIBLE CAUSE
-
Sub starter & generator
-
Harness or connectors
(Sub starter & generator circuit is open or shorted.)
FAIL-SAFE
Not applicable
Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine and let it idle for at least 180 seconds.
-
Check DTC.
Is DTC P15B0 detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK DTC WITH SUB STARTER & GENERATOR
Check DTC with sub starter & generator. Refer to CONSULT Function (SUB STARTER & GENERATOR).
Is DTC detected?
YES>>Perform trouble shooting relevant to DTC indicated.
NO>>INSPECTION END
Other materials:
U2384 Can Comm Circuit
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U2384
83
CAN comm err (eVTC)
[CAN comm err (eVTC)]
Diagnosis condition
Ignition switch ON
Signal (terminal)
CAN communication signal
87
Thresho ...
Symptom Diagnosis. Driver Side Power Window Does Not Operate
Diagnosis Procedure
CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY AND GROUND CIRCUIT
Check power window main switch power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHE ...
C1070-01 Side G Sensor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1070
01
Side G sensor
(Side G sensor)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
Signal (termi ...
