Nissan Rogue (T33) 2021-Present Service Manual: P15b3 Sub Starter & Generator

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P15b3 Sub Starter & Generator

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P15B3 00

Sub starter & generator

(Sub starter & generator) 		Diagnosis condition —
Signal (terminal) —
Threshold When the ECM continuously detects an abnormal signal (voltage detection function error) of the sub starter & generator for 2 seconds or more.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Sub starter & generator

  • Harness or connectors

    (Sub starter & generator circuit is open or shorted.)

FAIL-SAFE

Not applicable

Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 2.

CHECK DTC PRIORITY

  1. Start the engine and let it idle for at least 5 seconds.

  2. Check DTC.

Is DTC P15B3 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC WITH SUB STARTER & GENERATOR

Check DTC with sub starter & generator. Refer to DTC Index.

Is DTC detected?

YES>>

Perform trouble shooting relevant to DTC indicated.

NO>>

INSPECTION END

    P15b1 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P15B1 00 Sub starter & generator (Sub starter & generato...
    P1603 Ecm
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1603 00 CONTROL MODULE (CONTROL MODULE) Diagnosis condition —...

    Other materials:

    Adp Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). Driver seat control unit Harness con ...

    System Description. Component Parts. Drive Mode System
    Drive Mode System Component Parts Location No. Component Function 1. Drive mode select switch Refer to Drive Mode Select Switch. 2. Chassis control module Chassis control module controls the drive mode select system. Refer to Component Parts Location (without ProPILOT Assi ...

    Symptom Diagnosis. Panic Alarm Function Does Not Operate
    Description Panic alarm does not operate when press the PANIC ALARM button of Intelligent Key. Diagnosis Procedure CHECK INTELLIGENT KEY SYSTEM (REMOTE KEYLESS ENTRY FUNCTION) Press the LOCK button of Intelligent Key. Are all doors LOCKED? YES>> GO TO 2. NO>> Check Intelligent ...