Nissan Rogue (T33) 2021-Present Service Manual: U1ca1-08 Lin Communication 2

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U1CA1-08

LIN communication 2

(Local interconnect network communication 2)
Diagnosis condition Ignition switch ON
Signal (Terminal) LIN (A/C control) signal
Threshold A/C amp. is not transmitting or receiving LIN communication with A/C switch assembly or rear air control (with rear air control)
Diagnosis delay time 2 second or more

POSSIBLE CAUSE

  • A/C switch assembly

  • Rear air control (with rear air control)

  • A/C amp.

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “HVAC”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK DTC

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “HVAC”.

  3. Check following DTC.

    DTC

    Items

    (CONSULT screen terms)
    Reference
    B24B4-02 A/C CONTROL COMM DTC Description
    U1CB1-02 A/C control 2 communication DTC Description

Is DTC detected?

YES>>

Perform DTC diagnosis procedure that is detecting.

NO>>

Replace A/C amp. Refer to Removal and Installation.

    B24f4-14 Heated Steering Wheel Relay
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24F4-14 Heated steering wheel relay (Heated steering wheel ...
    U1ca2-08 Lin Communication 3
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1CA2-08 LIN communication 3 (Local interconnect network com...

    Other materials:

    U278c-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGICWith type B meter DTC No. CONSULT screen terms DTC detected condition U278C-88 Ethernet circuit Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold Lost ethernet communication with AV control unit Diag ...

    Régulateur de vitesse
    Informations de base Fonction de RES+ Fonction de SET- Touche CANCEL Commande marche/arrêt (ON/OFF) de régulateur de vitesse AVERTISSEMENT Respectez toujours les limitations de vitesse en vigueur et ne réglez jamais la vitesse du régulateur au-delà des limites autorisées ...

    Différence entre les distances indiquées par les lignes et les distances réelles
    Informations de base Les lignes de guidage affichées sur le moniteur du Nissan Rogue servent uniquement de référence visuelle. Leur position sur le sol est approximative et peut varier en fonction de l’inclinaison de la surface ou de la hauteur des objets détectés. Par conséquent, les objet ...